View the decoded Morse code in the serial monitor. Bekijk de gedecodeerde Morse-code in de serial monitor. And connect a buzzer between Arduino pin 8 and GND.
Most people to prefer a tone between 500Hz and 1 kHz. Locate a Morse code signal and tune the radio so the Morse produces a comfortable audio tone. Adjust the volume for a normal listening level. Connect the buzzer between GND and pin 8 of the Arduino and the Morse key (I use a tactile switch) between GND and pin 7. EASY BUILD CW DECODER BASED ON DSP GOERTZEL CODE. In normal use, connect the speaker output from your HF radio or Morse code source to the input socket on the decoder. En sluit een buzzer aan tussen Arduino pen 8 en GND. Setup the hardware by hooking up everything as shown in the schematic diagram. Connect a tactile switch (or key) between pin 7 of the Arduino and GND. The main category is Arduino Morse Code Projects, cw decoders, morse code keyers. Morse-decodeerder // (C) 2016 Demented hacker (thank you) // now working and translated #include #include //uses the standard i2c library // Verbind een tactile schakelaar (of seinKEY) tussen pen 7 van de Arduino en GND. The resource is currently listed in in a single category.
